I recently ran into an issue when trying to perform dual route processors password recovery on a Cisco ASR1006 Problem After breaking into rommon mode and using confreg to ignore the startup configuration, during the rest the ASR1006 loaded the startup configuration!!!!!!!! Solution So quick and simple, I pulled one of the RP and preformed password recovery running on a single RP. All went according to the Cisco documentation http://www.cisco.com/en/US/docs/routers/asr1000/install/guide/routers/asr1_hwc.html#wp1045971 After the system running on a single RP was recovered and fully booted I waiting for 5 minutes just to be sure; then I inserted the second RP and allowed everything to sync up. All was well again :) phew Note: The system was previously fully functioning with dual RPs; a configuration error was made during Tacacs+ configuration which resulted in lockout. Summary I hit an issue recovering and ASR with dual RPs, so rather that spending hour researching, I decided ve
This is a good subject to talk about. Sometimes I fav stuff like this on Redit. I think this would be the best to submit though. I will be sure to submit something else though.
ReplyDelete