Skip to main content

From IOS to Junos - Final Day - Part 1

In this final day I have reset the Lab then proceeded to reconfigure all the devices and capture the process on video. You can watch all my mistakes and also see how I jump around to troubleshoot some basic routing issues between the redistribution between routing protocols.


Factory Reset



Basic Configuration



Interface Check



Comments

  1. Michael Kantowski9 October 2011 at 06:09

    Very cool that you documented your experience learning Junos. I think everyone should have experience with multiple platforms, regarless of which one is your favorite.

    Right on!

    ReplyDelete

Post a Comment

Popular posts from this blog

ASR1006 Dual Route Processors Password Recovery - Tip

I recently ran into an issue when trying to perform dual route processors password recovery on a Cisco  ASR1006
Problem
After breaking into rommon mode and using confreg to ignore the startup configuration, during the rest the ASR1006 loaded the startup configuration!!!!!!!!
Solution
So quick and simple, I pulled one of the RP and preformed password recovery running on a single RP. All went according to the Cisco documentation

http://www.cisco.com/en/US/docs/routers/asr1000/install/guide/routers/asr1_hwc.html#wp1045971



After the system running on a single RP was recovered and fully booted I waiting for 5 minutes just to be sure; then I inserted the second RP and allowed everything to sync up.



All was well again :) phew



Note: The system was previously fully functioning with dual RPs; a configuration error was made during Tacacs+ configuration which resulted in lockout.


Summary
I hit an issue recovering and ASR with dual RPs, so rather that spending hour researching, I decided very quickly to go …

From IOS to Junos – JNCIA Result - PASS

I done the exam, and I am please to say I passed. So the lab-ing and the two PDFs

JNCIA-Junos_SG_part_1_09-16-2010.pdf
JNCIA-Junos_SG_part_2_09-16-2010.pdf

And a bit of surfing the web were enough. That is not to say everything in the exam was familiar, I did have to think seriously about some questions which puzzled me.
So the next step will be to go for specialist, but because of workload, it's going to take a little longer that 15 Days.

NetGuruSubnetCalc

This is a straightforward no nonsense Subnet Calculator. It does however allow you to pull up the subnet information you have been working on in the iPhone Todays Widget View. This means that the subnet information is just a slide away.




Developed my me. Now Available

http://itunes.apple.com/gb/app/id941632787